Competition Looking for good shops to do a Fire ring setup in the northeast

[therabbittree]

I am looking to build a engine for the spring etc that will need to be fireringed. It would be a bare block and head. I would like to find a shop with a deck plate to hone the block too. I'm in NY, but willing to travel a few states to get it done right. Any shops? I know Scot at Mass Diesel can firering . . but I don't think he has a deck plate... Any Ideas, suggestions.

Thanks,

Deo

 

[BGarofalo]

Im in Northern NJ not far from you and have the same question. There are a few shops by me that say they can do it, but have never done it on a cummins. I know of Auto Wurks Diesel in NJ but havnt heard the best things about them and the prices are a little steep. Any other suggestions?

 

[Signal73]

try tricountymachine.com they are a full machine shop and do oringing/firering not sure if they deck tho, but worth a shot. he is in lebanon ct

 

[RobertP]

there is a place called east coast diesel in PA that does good work.

it owend by ladell weaver. he is a great guy to do business with.

i know a bunch of guys who have had firerings and such done there and are very happy with it.



Robert

 

[Timebomb]

East Coast Has A Very Nice Deck Plate As Well.

 

[therabbittree]

Does any one have any contact #'s for Eastcoast Diesel etc?

Thanks,

Deo

 

[RobertP]

pm sent

 

[Graphic man]

Doug is in PA also



http://www.performancedieselwarehouse.com/

 

[Redram 1]

re

Ryans garage has a fire ring o-ring tool with a deck plate,just below Erie Pa. Does a nice job and he is cheap. 814 967 5228.

 

[Highfinance97]

I know of Auto Wurks Diesel in NJ but havnt heard the best things about them and the prices are a little steep.

HeHe :-laf :-laf



Michael

 

[6BT-Dakota]

HeHe :-laf :-laf



Michael

My thoughts exactly ! ! !

 

[RacinDuallie]

Buddha Power is in Ohio.....

 

[HoleshotHolset]

AFAIK, Scott has a deck plate.



Too bad you weren't out here - I know my buddy Jim could help you out with his cutter/plate/etc.



Matt

 

[therabbittree]

thanks matt nice to know . . im still tring to figure out the build specs . . etc. . oh and blake and his dad just got a bridgeport milling machine and they have two lahes now up at the hanger... I think I may be flycutting my own pistons for the vw and the cummins and may be trying a intake cut off for the cummins...

Later

Deo