Here I am

lost power

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

vacume brakes

Stripped Pyro install

Status
Not open for further replies.
my 1996 4x4 5spd 3500 HAD the power to pull with anyone but noe I need to stay in the right lane out of the way I pull a 98 avion with a pin weight of 2617lbs. the only thing I have noticed is the turbo is very quite it did whistle How do you test the performance of the turbo

------------------
 
You need a boost gauge, without one all you can do is guess what's going on. A pyrometer is another gauge you need to really monitor your engine. Other than that you can pull the hose off of the intake of the turbo to see if it spins freely and tighten all your pressure hoses going from the turbo to the intercooler and from the intercooler to the intake.
 
My 96 did that and the overflow valve spring was weak. It should measure . 500. If its not , stretch it to . 550 and reinstall, if its better buy a new overflow vale as that will be a temporary fix. My local fuel injection place has Bosch valves for $60. 00 so check around, DC will getcha otherwise.
It takes about 15 minutes to R+R the spring, just put rags under the fitting area so you dont lose the sealing washers.
Good Luck
John

------------------
97 SLT Laramie CC 5spd, 3. 54, Ranch Hand front and rear. Gauges, EGT, Boost, fuel pressure, oil temp,indash CB, custom switch mount-6 switches BD brake extra fuel tank 45gal. Oh oh dang cat fell off, took the muff with it. Member NRA/USPSA
 
Status
Not open for further replies.
Back
Top