Here I am

2nd Gen Non-Engine/Transmission lower ball joints + caster

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

2nd Gen Non-Engine/Transmission Who Makes Air Ride Kits?

Engine/Transmission (1994 - 1998) Question About 12V Valve Cover(s)

Status
Not open for further replies.
I was adjusting the caster on my truck yesterday and noticed that my lower ball joints had an 1/8 " of up and down play in them is this normal for a truck with 40,000 miles? Also I adjusted my caster from the stock setting at 12:00 -12:30 to 10:30 11:00 the truck does drive a little better,will adjusting it further out make it track better,where I have it adjusted now is as far as I want to go before the trackbar hits the diff, cover. any suggestions thanks. Gregg
 
so It looks like mine are shot,does anyone know what the max is on the caster, as I stated before I am concerned with with a clearance issue with the differential cover and the trackbar ball joint.
 
Status
Not open for further replies.
Back
Top