Attention: TDR Forum Junkies I have adapted front mount intercoolers to cars that are dificult to duct I use mandrel J bends from summit one could use 3 inch (flowie
)cut & weld. for my truck Im gona make everything from the compressor to the intake Ill post pics when I get it done
these should flow better than the wierd cast elbows used by dodge
if I get a good patern going Ill put a couple in the clasifieds
take care
JAK
)cut & weld. for my truck Im gona make everything from the compressor to the intake Ill post pics when I get it done these should flow better than the wierd cast elbows used by dodge
if I get a good patern going Ill put a couple in the clasifieds
take care
JAK
