Here I am

2nd Gen Non-Engine/Transmission Missouri State Rep - truck pull

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff
Status
Not open for further replies.
does anyone know the (I think he was a state representative for Missouri) that pulls this black dodge short bed? I was wondering what kind of setup he has. I saw it pull a month ago and it was one mean truck...
 
You are looking for Larry Crawford, posts as Roger Rodbolt. One heck of a nice guy, shoot him an email with your question, a quick search on his handle should turn up his info.
 
The same set-up everybody else has that is serious about pulling--A Mitchell clutch!!



He'll post soon, no doubt.



He won 2 classes at Muncie, beat some trailer queens.
 
Yeh! It was wild to watch. . And thanks for the clutch info, I have a buddy who wants to start pulling his truck and is afraid that the southbend may not hold... or will it??
 
Last edited:
I met Larry this weekend at a small pull here in Missouri. Very nice guy:) . He does put on a good show. He tried to enter the open class (anything goes, right?) but when he and another rippin Dodge tried to enter they changed it to 6200# open. They ended up making a Diesel class for them to pull in.
 
Mitchell Clutch

Turbo LCC,

Sorry to be slow to post but Sled Puller covered it, the Mitchell clutch is a great setup for sled pulling. My wife (she doesn't like to drive any manual trans) drives my truck in parades while I stand in the bed and throw candy... ... ... ... ... that should say a lot for it's streetability.



78repowerwagon,

I enjoyed meeting you this weekend and good luck with that intense blue CTD. Should we mention that one of the white CTD's pulled a MY6EatsV8s show and scattered his receiver hitch down the track? He should have gotten the recall done :eek: :), Larry
 
Last edited:
Status
Not open for further replies.
Back
Top