2nd Gen Non-Engine/Transmission MN Peeps, Need some help!

[Alphacowboy]

Was wondering if any of you minnesota Twin Cities area folks are up to a challenge? I want to under go my AAM axle swap in the next month, and am going to need some help from some fellow TDR fellers to accomplish this task.



Here is what I need,

1. ) Above all, some friendly faces willing to swing some wrenches!

2. ) A shop, or Large Garage, as I dont fit in mine, so it wont work, and my driveway is gravel.

3. ) A welder and someone that can wield it! I dont know how to weld, only tack stuff. Reason for this is, welding on the new ThurenFab Trackbar mount! and to weld on some new perches on the rear AAM axle as the 3rd gen perches are too far apart for my 2nd gen.

4. ) Air tools, as it would make life a little easier.

5. ) Someone willing to drive my *** to the parts store for parts I didnt think of prior! :-laf



So, who wants in on this experiance? For those of you that havent seen Dons tracbar up close, will get to see just how beefy this sucker is in person!!!



Thanks guys!

-Matt

 

[Schlickenmeyer]

I may, but life is very crazy right now, so it depends on the timing. .

I can offer #1, #4, #5. Have not done any welding in years, could use the

refresher. . Feel free to keep me posted here or pm, just dont count on me.



Good Luck!

 

[wildmanben]

Matt.

I can do all of the above if you want the drive down here though...

 

[CrazieAbe]

I can help out with 1,4,5. Might be able to find a shop to do it in to, but not sure yet. I'll have to make some phone calls. Let me know when...

 

[JFaughn]

#1 , 2nd half of #3 [ welderless welder ] & #5 .
My computor died so I do not get to check the forms very offen , but will watch for this .