Engine/Transmission (1994 - 1998) My 546 hp 12V dyno vid

[pwerwagn]

Just thought Id share. .

made 546hp and 1188 ft lbs on the best pull. The little dodgezilla was making between 42 and 44 psi, and burying the pyro.

It was a load type dyno, and the load/accel rate was set at 150 rpm/sec upsweep.



http://video.competitiondiesel.com/video/a430400c-2388-4e2f-822f-98fc00e23f26.htm



--Jeff

 

[Signal73]

like the soot mark left on the pavement:-laf

 

[Forrest Nearing]

546 on a Dodgezilla and a stock head?!??!???! yeah, I bet the EGT's were a tad toasty!!!



what else do you have done to it? I did 535 w/ DDP4's, sps62, ported head, and 18. 5* timing. EGT's will just touch 1600* at the end of a good run

 

[bgilbert]

I need to go out west for a big number!

 

[MMeier]

I need to go out west for a big number!

May Madness is but a few weeks away!

 

[Forrest Nearing]

I need to go out west for a big number!

heck yeah, I bet I could do 600 out there! :-laf

 

[pwerwagn]

yeah, I dunno how close these numbers compare to other dynos. It was a land and sea dyno-mite. With the loading setup, not the interia setup. The correction factor was quite high that day. I think my uncorrected numbers were 490 ish.

I was burying the pyro by 2200 rpm. Im sure it was getting well in excess of 17-1800*.

But yeah, it was done with a DZ wiht a ported housing, scotty intake, 4", Joe D/Don M injectors, and a plate from Joe.



--Jeff