Here I am

Need a good trac bar. Axle out of center.

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

banjo bolts

operating temps

Status
Not open for further replies.
I a trac bar that will put my axle back in the center.

I measured from the frame to outer edge of tire in line with axle.

Driver side was 24 1/2 inches. Passeger side 23 1/4 inches. It is a noticeable differince.

I begining to think maybe about taking the coil spacers out. There was no mention that so many things go out of wack. Next time a lift kit will be considered.

I should have just shortened up the blocks on the rear end to make it sit a little more level.
 
DT make an adjustable track bar that will solve this problem for you. I don't have their website offhand, but maybe someone will post it.



As far as other things being out of wack, this is probably the #1 reason I haven't thown in a set of spacers myself. All this talk of the death wobble has me a little concerned. It seems like (and hopefully it will be the case) that a DT trackbar, upgraded control arms, and the prpoper alignment specs will keep the truck as close to OEM as possible. Maybe not?



Good Luck,

Ryan
 
call Mike

Jeff;



Call Mike Adams at 701-587-6335. This is one of many things we talked over in making plans for the February 9th get together at his shop. You should also mention injection timing if you're still interested.



-John



I am not employed by nor compensated by <b><small><font color=red>MIKE'S CUSTOM TRUCK BUILDERS</font></font></b>. I simply recommend quality businesses and this is one of them.
 
Last edited:
DT Trackbar info

Here is contact info for DT Trackbar. I don't have one but have researched it some and they seem to be the best aftermarket option available. Now, if I just had some money.



PS If you go to the web site, it's not up to date. It was created for them by a satisfied customer and it's not really theirs. You can get the most up to date info by calling them directly.



DT Pro Fab

484 EZ St

Prescott, AZ 86301



Toll Free 1-888-776-2403

email -- email address removed --

http://www.angelfire.com/az/dtprofab/index.html



Bill
 
Last edited by a moderator:
Status
Not open for further replies.
Back
Top