Here I am

new compressor wheel

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

First Gen Day; Would it be too much?

Raise Front End

Status
Not open for further replies.
HTML:
Marginally competant?? Hey!!! I cut one for you Jay



Oh sugarfoot... . Paul, that's not what I meant!!! :-laf

You did it with your eyes closed in ten minutes... that makes you marginally competant + ;)
 
Luckily I still have all my digits... .



Picture it - Center section is mounted to a large LeBlonde (I think that's how you spell it) lathe being held by the thin outer edge. Push the go lever and OOOOHHH that's not what I wanted to do! :--) - (strange grinding noise out of lathe transmission) A couple of heads pop up from across tool room. luckily its break and, well, lets just say don't bother them during break... Stop and try moving lever in a different direction. Great! It spins correctly, at the right speed and I haven't tossed someone elses center section across the factory. I have to do all of this while no one is near by in the tool room (boss or any other nosy tool makers). :-laf
 
Status
Not open for further replies.
Back
Top