New Egt Gauge Dosent Light Up - Help

[JNeeley]

long story but bulb not working in my new egt gauge in 3 gauge A pillar pod, other two light up. Just picked up. Any ideas

 

[MMeier]

Ummmm..... replace bulb???

 

[JNeeley]

How do I access the bulb? does the cover come off or what. No info on the Danin site to help.

 

[p-Bar]

Bulbs are usually replaced from the rear of the gauge, at least all the ones I have seen.

 

[BGlidewell]

did you use the danin wiring harness? If so, I would check continuity from the light power wire to the EGT connector light power pin. Also, the POTs they use in their harness are not very good. One of mine was open and would not pass current to the light. I removed them all.