Here I am

new rear leaf spring

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

'03 Rear Seat Light

Speedo Calibration

Status
Not open for further replies.
i am thinking about getting some springs made from national spring. does anyone have anything to say good or bad about their experience with them. from what i have read it seems like mostly positive comments. I have a skyjacker 4. 5 lift so i am going to have to get the springs with some lift on them. what would be a good tongue weight to tell them i don't pull that often but i don't want it to sag when i put something in the bed or two jet skies or something like that. i am thinking about 750 or 800lbs that should be plenty for me. thank for the input



Trey
 
Tpruitt,

I had them do a pack for me 2 years ago. All in all i am very happy w/ the results with one exception. I requested a 1 in lift to match my 3 in spacer in front. After install my truck was 1 inch lower :mad: They hadn't done any ctd's and didn't believe me that the rear weighed 2970 lbs:mad: They offered to rearch them for me but that would mean another $200 for removal and $ 200 for installation. And i could not take it down there (90 miles) and leave it for 4 days as it is my daily driver. So they sent me 2 in blocks and new u bolts to get me my 1 inch lift. I didnot want lift blocks but didn't have much choice as they would not remake them for me. That being said the ride is much improved over stock and i go all over the desert including climbing hills in 2 wd due to all the articulation of the new springs.



I told them 500 lb trailer tounge weight and i recommend you don't tell them anymore than that. 1600 lbs of sand bags lowers the back about 1 1/2 inches so all is well. They are 2-stage to handle the 28 ft trailer as well as provide a smooth ride when empty.



you might try Deever spring. They are supposed to be a little more modern of a company and might be able to beat the $ 700 i paid two years ago.



Best regards



DD
 
what was the over all weight of the rear of your truck i am having a hard time fining my the scales i went to they were broke and the next closest are 2 hours away. i weighed them once but i cannot remember what they were. also what is the length of your bed and are you a 2500 or a 3500. thanks for the help.
 
Status
Not open for further replies.
Back
Top