Here I am

New wheel bearing hubs and Universal joints

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

'04 Bodybuilder frame rail drawings ?

04.5 Build Plan

Hello all possibly someone has seen this before and can offer up some assistance, I just installed new hub/bearing assemblies and outer universal joints on my 2006 Dodge 3500 CC dually.

I read through the 10 pages of 120 posts about ABS in archives and didn't see anything quite like what I'm seeing.

Now I'm getting ABS errors I was not getting before, (4) coded stored 1st time C1036, C101C, C1011, C2206 I installed Timken hubs p/n HA590032 which are supposed to be the ones I need, the plugs on the new hub did not mate to the truck harness, I modified the new plug with my Dremel to fit/ mate to the old harness, "why did you do that" I had already fully assembled the hubs/axles etc. and not looking to pull apart again easier to trim the new plug to match the existing on vehicle harness.

Are the sensors polarity sensitive ? it is an A/C signal generated by the Hal pickup, so should not matter, that said the driver side vehicle harness (2) wire is green solid, and green with brown tracer stripe on other side, passenger side is (2) wire green solid, and green with white tracer stripe.

Any thoughts ???
 
Back
Top