Here I am

no power windows

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

Salesman In California with Integrity!

where to find ignition on hot source

Status
Not open for further replies.
Can anyone give me any ideas on why my power windows just quit. Checked the main fuse all O. K. Is there any other fuse the book don't tell you about. It is not the lock either. It is all windows nothing. 03. stick
 
There should be a circuit breaker, not a fuse (according to the service manual). If that is ok and there is power to the main switch, I would bet bad switch. Probably faulty within the lock button itself.
 
Last edited:
Actually, I just had the same problem--checked everything and it was a no-go. Turned out to be the ignition switch needed replacement. The circuitry for the windows feeds through the ignition switch. Dealer replaced it under warrantee, said it was a bad contact in the switch. Had me going nuts trying to figure it out myself, and I had the service manual to look at.
 
Status
Not open for further replies.
Back
Top