Non-slip Fold Flat Floor

[bighammer]

Has anybody put something on the folding floor to keep stuff from sliding around? I'm not sure how much room there is for any kind of thickness, but I'm tired of everything sliding side to side on turns & curves.



Just fishing for ideas.



Thanks

 

[tpuig]

I tried some non-slip rubberized spray. The same type you dip tool handles into. Results aren't exactly what I had hoped for. It worked ok, but now it's starting to peel.

I think I'll remove the floors and brush on some paint mixed with clean sand. Or maybe try some adhesive strips like the ones used on stairs.

TP

 

[Peter Campbell]

I took them out and had them Rhino-lined at the same time as the bed of the truck. Just remeber to mask or tell them to mask the center hinge part where it is close ( small flat area near center hinge ) also mask the "prop rods" peelling the material off those was a pain. They are on the back but there is an easily overlooked hole that will let the spray go right on the rod. Ran me 75$ in new york. Looks really good.

 

[BIG BOB]

I put the adhesive strips like used on stairs on mine. I put it on every other ridge. It is better, but sometimes things still slide a little. However it is alot better than nothing! Very cost effective.

 

[NSperduto]

How about a can of spray on bed liner. Similar to what rhino liner would do

 

[Spyke]

I used a piece of rubber deck matting absorbs some sound also, only problem is you have to remove it to fold the floor up. I leave mine down so I only remove it 1-2 times every 6 months



Steve

 

[Digger]

I just use a good old bungee cord.



Dan