Archived now injectors

[PetesonM]

I got the injectors pulled out and am replacing them with the 375's. I know with the 375's I need to use the thin washer. My question is when I pulled my stock injectors out there was no washer or I can not seam to get them out if they are in there. Both the new and old injectors have a thick 'washer' on the end, do I need to remove that on the new ones ? and just run the thin (. 020?) washers? I am not torquing anything down yet but I need to figure this out ASAP.

 

[REFLOYD]

i am assuming you are talking about the '95 if so remove the thick washers and use the thinnest ones. torque hold down nuts to 44ftlbs

 

[PetesonM]

Yes I am talking about the '95. Thanks a ton! I guess the thick washers are the ones from the factory. The kit I got from CityDiesel came with 3 other sets of copper washers I knew to use the thin ones but didn't know if that was in addition to the one already on there.

 

[REFLOYD]

yes the thick washers are on there from the factory. also they are 370's not 375's

i got the same ones from city diesel. good injectors for the money.

 

[bmoeller]

Remove the washer that was on the new injectors, and use the thin one that is in the kit, all by itself. Not stacked up with the other.

 

[p-Bar]

use the thin one