Engine/Transmission (1998.5 - 2002) NV5600 temp?

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

Engine/Transmission (1994 - 1998) Shudder

Engine/Transmission (1994 - 1998) Belt Tensioner Revoval?

Status
Not open for further replies.

DGerth

TDR MEMBER
Does or has anyone have data on the tempurature, Normal, for the NV5600 6sp ? I just had to replace mine at 190k for a princely sum and am wondering if a cooler running temp may = longevity. Thanks in advance. Am going to overfill this one by some. This was not purchased from Standard Trans in Ft. Worth with their "oiling packg". Thoughts?

Tks in advance,

dg
 
Hi,



Although mine is an 05 with the 5600, here's what I did. I put the Fast Coolers on and then overfilled to the fill plug on the Fast Coolers. This should be 8-9 quarts total. I have a transmission temp gauge and during 100* Ambient Temps at 70-80 on the Interstate it will run about 190-200* empty--after at least 50-60 miles of highway. It takes a long time to warm up! I have heard that the temps may reach 230* during heavy towing, but I haven't hooked up to something in a while (atleast not since putting a temperature gauge in).



My theory is that increased lubrication equals higher longevity. Some on this site have noticed an increase in temperature by 20-30* just by overfilling it. This may be due to the fluid being able to more adequately bathe the bearings--thus, running hotter due to increased lubrication and heat absorption from the normally unbathed parts. I think Standard Transmission recommends overfilling (based on a post I read on TDR--PLEASE DO NOT TAKE THIS AS THEIR POLICY AS I MAY BE MISTAKEN) so their is a lesser chance for bearing starvation on increased grades when heavy.



Just my thoughts...



Cheers.
 
I'm pretty sure Gary K7GLD did a major write up on trans temp studies, search for posts with your Q and his name.
 
Hi,



Although mine is an 05 with the 5600, here's what I did. I put the Fast Coolers on and then overfilled to the fill plug on the Fast Coolers. This should be 8-9 quarts total. I have a transmission temp gauge and during 100* Ambient Temps at 70-80 on the Interstate it will run about 190-200* empty--after at least 50-60 miles of highway. It takes a long time to warm up! I have heard that the temps may reach 230* during heavy towing, but I haven't hooked up to something in a while (atleast not since putting a temperature gauge in).





Cheers.







Pretty close to mine... its not a linear increase, but pretty close to 100*F over ambient temperatures with coolers. I saw 230* once, prior to installing coolers. Since then I have only hit 200*F at 115*F ambient once.



Sometimes prolonged continuous driving will make them run hotter than the 100*F over ambient, but its not by much. If you watch it, you can actually see the temp climb when pulling a grade and cool down when descending a grade... just like and auto.
 
I'm pretty sure Gary K7GLD did a major write up on trans temp studies, search for posts with your Q and his name.



Mine wasn't a particularly major effort, but did try to show temp rise on the 5600 in my particular '02 truck, used primarily for 5th wheel towing in the 14K GCVW range - with lots of mile high towing in steep grades, and 100 degree summer temps. I usually saw - after the mods shown in the first thread pointer below - a nominal 50 degree temp rise - note that I was taking my readings at the CASE, not directly immersed in the lube itself, so arrive at your own conclusions as to readings and effectiveness:



NV-5600 cooler and filter - TDR Roundtable



Unfortunately, I have no "pre-mod" temps for comparison, so can only compare my own readings with what a few other members posted in the threads provided here - but mine SEEM significantly lower in rise in towing situations than most non-modded trannies...



Here's another:



NV-5600 lube temps... - TDR Roundtable



As stated in that last pointer, I use the standard OEM lube in my transmission - tried a few others, including some rather high priced synthetics, but shifting quality really suffered with anything but the OEM lube.



The digital thermometer I used, as can be seen in the pictures, topped out at 156 degrees - and only went off scale once during the time I had it installed - on a long steep grade in 100 degree weather - and only for a minute or so as I topped the grade and started on the downhill side.



YMMV! ;):)
 
Status
Not open for further replies.
Back
Top