Engine/Transmission (1994 - 1998) Oil pressure sender

[DavidNH]

I have a 95 CTD trapped inside a parts truck that is going to get pulled. I have the engine disconnected from the chassis electrical system and the ECM is gone so is the wiring harness to it. I can start and run the engine, but would like to know stuff like oil pressure & coolant temp. I need to install a bourdon tube oil guage and a mechanical coolant temp guage under the hood somewhere just as a temporary provision for assesing the health of the engine. Where on this engine can I find the oil temp sensor location and the same for the coolant?





Thanks,

Dave

 

[Joe G.]

The oil pressure sending unit is on the block behind the power steering unit. The temp sending unit is on the block just below the rear of the head on the driver's side.

 

[DavidNH]

Thanks again, appriciate it.

Dave