Overhead gauge pod pic's

[Kennywould]

A little bit of work but I like it!https://www.turbodieselregister.com/user_gallery/displayalbum.php?&albumid=17155

 

[moparguy]

Great job. I like that a lot. So, where did you find the gauge pod, my guess is it's a dash mount.



Another thought is the lenght of leads to the gauges, was everything long enough.



RJR



added in edit: just read the other thread, guess I need to keep up with the products out there.

 

[Kennywould]

It is a windshield pod by Gaugworks, from Geno's catalog. Had to lengthen the pyro wiring eveything else worked fine.



-Ken

 

[Cummins Pilot]

Wish they made that setup for my 2nd gen. Right now I'm trying to figure out where to mount my next three gauges. I have three on the pillar but I don't like the look of a dash pod. I think I'll put them where the vents are over the radio.



The vent on the left side by the door now is the Espar timer unit. And then I need to mount switches, where will ten of them go??



BTW that looks good Ken.

 

[mgratner]

Ken,



Great pocs. Where did you install the trans temp. sender and how did you extend the wiring?



Mike

 

[Kennywould]

Where did you install the trans temp. sender and how did you extend the wiring? Mike

Well I put the sender in the rear test port on the passenger's side but I don't know if thats where it belongs, as far as the wiring goes I ran an 18 gauge wire from the gauge to the sender, there was no wire with this gauge, picked up a swithed hot from the ignition and light from the clearance lights overhead



-Ken