P/N For supply line to injection pump.

[sparks57]

Anybody know the P/N for the supply hose and nut on the pump? PB said he had it... but he NEVER responds to his PM's so I'm asking you guys! J/K PB!!!



I need the hose it's self, either comming from the joint in the middle of the hose or the whole assembly, plus the flow-through nut that attaches the hose to the larger tall nut that attaches to the pump it's self.



Mine was kinda trashed during the latest pump R&R, and I need a new one. It's on, but it's leaking like a siv because I can't rotate the thing to tighten it...



Thanks guys!

 

[dpuckett]

There should be a tag on the line itself (wrapped around- if you dont know what you're looking at, you wont know it's a p/n tag) that has a part number on it. Many of them start with a 3; should be 7 digits. May have to take a pocket knife and do some scraping to get it to show.

 

[BushWakr - RIP]

Now Chris... I didn't say I had the part number I said Piers personally went to Cummins to get the front section... the metal line because the part number in the catalogue is not right for the part in question.

I also, always try to answer my PM's...

I'll see if I can get the part number from Piers tomorrow when I go into the shop.



pb.

 

[sparks57]

Oh, ok... well, I was just kiddin' with ya anyways PB!



I'll run out tomorrow morning and look for a tag... I did notice that there was a little floppy doo-dad on the hose and maybe it's the tag.

 

[dpuckett]

That little floppy doo dad is mostl likely the tag.



-DP