I was planning to install my new amp under the passenger seat. I decided to pill the other seats & the rubber floors to run the wires & put down a couple of layers of b-quiet while I was there. The passenger floor is wet from about where the A/C drain is back to the seat. It is clear water, not anti freeze.
I have the sound deadener that goes under the dash propped up & a heater running in the cab to help dry it out. Any ideas what I can do to seal it? or did I start a much bigger project than I planned?
I have the sound deadener that goes under the dash propped up & a heater running in the cab to help dry it out. Any ideas what I can do to seal it? or did I start a much bigger project than I planned?
