Here I am

Patching plastic fuel tank

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

Towing with 12 cm vs 18 cm

Cruise Control Installation Question

Status
Not open for further replies.
Anyone have any experiences/suggestions about patching a puncture in a plastic fuel tank on a first gen truck?



Thanks,

Andy
 
Look for a aircraft repair shop. You need some fuel cell sealer. This is two part epoxy based.



Clean the tank. Make sure there is no liquid on eather side of the hole. Inside or out. The apply as needed. Let set for 12 hours or so. You should be set to go.



If the hole is a large one. You might need to put a patch on it. Then use the sealer.
 
Status
Not open for further replies.
Back
Top