Engine/Transmission (1998.5 - 2002) photo of digital fuel gauge installed

[emarsh]

look under which fuel gauge to install, this forum





look under which fuel gauge to install, this forum



or look here! The gauge is a cyberdyne, with an 0 to 18 PSI electric sending unit. Purchased from Jegs, believe cost was aroung $60 including singe hole bracket.











#ad

 

[emarsh]

ttt

 

[JCockrell]

looks good and...

s/b well protected. I went out to the truck and "at a glance" I may have to find something to put in that same location. HMMMMM another SPA gauge ?????? Nice one emarsh.

 

[jdkenyon]

I put my fuel pressure gauge in the same location. A few weeks after installing I almost ran into a problem. The 4x4 shifter in 4-low hits my gauge. The gauge mount is flexible enough that the shifter just pushes it a little out of the way. If your mount is solid and you have a 4x4, you might double check it.

 

[duaneparks]

The gauge is cool, but SO IS THAT SHIFT KNOB. Dang that's sharp. What is it? I've been looking at replacing the stock knob for a while, and I'm not real excited about the Eaton Fuller deals.



What you have is a nice alternative.



Duane

 

[duaneparks]

TTT



I still want to know about that shift knob... what is it and where can I get one?



Duane

 

[rono]

Same question as duaneparks, tell us about the shift knob. What kind, where did you get it etc...

Ron

 

[duaneparks]

TTT

 

[GiesJ]

I could be mistaken but I think that is a fatknob. there was a thread a while back on them...

www.fatknobs.com

I'm not positive and hope that emarsh confirms.

later

 

[emarsh]

yes that is confirmed, a fatknob. thread size is 10mm x 1. 5 ED