Attention: TDR Forum Junkies 
Hi Guys. .
I just finished putting the boots on the driver's side, will replace the other side when my turbo arrives. My question is. . How tight are you supposed to tighten the spring loaded clamps?
These boots are pretty stiff and don't really want to slide onto there prospective places. Not liking to struggle with anything, I took my pocket knife and cut about a 1/4" bevel on the inside of each end, that, along with some hairspray(and an extra hand) made them slide on a whole lot easier.
Thanks,
jdooner
98. 5, Green, 1. 5 EDMs, Comp, Smarty, 4" turbo back ex, Marv's auto trans, X-monitor, and a bunch of stuff on garage floor awaiting my attention...
I just finished putting the boots on the driver's side, will replace the other side when my turbo arrives. My question is. . How tight are you supposed to tighten the spring loaded clamps?
These boots are pretty stiff and don't really want to slide onto there prospective places. Not liking to struggle with anything, I took my pocket knife and cut about a 1/4" bevel on the inside of each end, that, along with some hairspray(and an extra hand) made them slide on a whole lot easier.
Thanks,
jdooner
98. 5, Green, 1. 5 EDMs, Comp, Smarty, 4" turbo back ex, Marv's auto trans, X-monitor, and a bunch of stuff on garage floor awaiting my attention...
Last edited:
