Here I am

2nd Gen Non-Engine/Transmission Pivot Bar bolts

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff
Status
Not open for further replies.
Will be doing the ball joints soon and while I am there the upper control arm bushings will get replaced as well. I can't find the torque spec. for the bolts that hold the pivot bar in place. Anyone know what they should be torqued to?



Thanks, Scott
 
Torques

Upper Suspension:



Pivot bar nuts... ... ... ... ... ... ... . 155 ft. lbs.

Ball joint nut... ... ... ... ... ... ... ... 60 ft. lbs.



Lower Suspension Arm:



Frame nuts... ... ... ... ... ... ... ..... 145 ft. lbs.

LD ball joint nut... ... ... ... ... ..... 95 ft. lbs.

HD ball joint nut... ... ... ... ... ..... 110 ft. lbs.



Hope this helps.



Ed
 
Ed,



Thanks for the info. That helps a lot.





Nate,



The pivot bar is between the upper control arm bolts. The pivot bar is what holds the upper control arm to the frame. It's what they use to align the front end.
 
Status
Not open for further replies.
Back
Top