Here I am

Possible front axle bad?

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

question for those who have done exhaust work

A/C Leak

Status
Not open for further replies.
I'm getting some screeching/squeeling in my front left tire area on my 03 3500 quad cab when I turn. No noise on straight runs. Not sure if I have an axle joint issue or something with the brakes. Sometimes there is a light klunking noise. I read some other inputs about axle U-Joints... . just wondering if it could be something else. Any ideas?
 
Ball Joint?

I'm getting some screeching/squeeling in my front left tire area on my 03 3500 quad cab when I turn. No noise on straight runs. Not sure if I have an axle joint issue or something with the brakes. Sometimes there is a light klunking noise. I read some other inputs about axle U-Joints... . just wondering if it could be something else. Any ideas?



Could it be a ball joint if the tire has movement off the ground?
 
I'm pulling my axles shafts and doing U-joints this week.



I have the same kinda noise and I am 99% sure it's the u-joints.
 
Let me know how that goes... I'm going in this weekend to change the fuel filter and check the u Joint. Good luck on the change out!
 
I'd bet it's u-joint as well, but while we're on the subject, does anyone know how much play is supposed to be present in the ball joints? While doing my last u-joint R&R, I noticed movement in both sides. I can't tell anything is wrong while driving it, but they sure look like they need replaced. I have 73k on them.
 
I think if you jack the front wheels, turn the wheel to one side or the other and spin the wheels (by hand :p) you'll find it
 
I'd bet it's u-joint as well, but while we're on the subject, does anyone know how much play is supposed to be present in the ball joints? While doing my last u-joint R&R, I noticed movement in both sides. I can't tell anything is wrong while driving it, but they sure look like they need replaced. I have 73k on them.



I just checked mine tonight. I have . 015" play when prying up on the knuckle. I think they are OK, but am not sure on the tolerance they should have.
 
I think if you jack the front wheels, turn the wheel to one side or the other and spin the wheels (by hand :p) you'll find it



Yep, or if you have the bad part of the joint pointing up and down and just turn the steering wheel side to side while it's up in the air you can also hear it.
 
Status
Not open for further replies.
Back
Top