Preparing for POD install...

[MikeO]

I have all the washers and o-rings. Planning on installing them at the Northeast GTG on the 30th.



Someone is bringing the puller and I'll bring all the rest of the tools. What do I need to clean the bore before installing the new ones?



TIA,

Mike O.

 

[RFox]

when i changed my injectors i cleaned the bore out with a copper wire bore brush for my 12 gauge shot gun... it worked pretty good. .

 

[JLEONARD]

Someone is bringing the puller

Hey. . that would be me!

I guess I'd better blow the dust off it and pack it in the truck... ...

along with some brushes by the sounds of it.

Mike. . I found that a thin screwdriver with a rag wrapped aound the tip was a good tool for cleaning the sealing surface of the bores. If you could rig a small diameter hose onto a small shop vac that might help to suck out the dirt.

Jay

 

[MikeO]

Hey!

Thanks Jay.



I will bring some wire brushes, my portable air tank with the blow nozzle and my DeWalt battery shop vac.



See you next weekend!



Mike O.

 

[Moose Truck]

Thanks Jay.



I will bring some wire brushes, my portable air tank with the blow nozzle and my DeWalt battery shop vac.



See you next weekend!



Mike O.

Tourqethis has an aircompressor there already, Moose.



Ps Bring on thoose First Gens, My 1st CTD was a 89 4X4 Auto, Wrecked at 225 K :{