Engine/Transmission (1998.5 - 2002) Quad commander intalledand updated 5# boost at Idle?

[Arctic Taco]

Howdy all,

Got the quad commander installed except for the EGT sensor-left it and the tap at work. So after the install went for a test run and downloaded the up date for it. Prior to update 0# boost @idle, post update 4-5# boost @idle WTF? Have installed the AFE intake with the lid but this was in place prior to the Commander. By the way Be excessively careful with the VERRY wimpy connector for the EGT from the commander harness, pulled out twice-(second time after I had already fished it through the firewall#@$%!) so I am going to solder some bigger wire to the ends and use bullets i guess to hook it up.

Any ideas about this? I am also writing to Quadzilla about this update question:-{}.

 

[MA2LA]

I have had mine on for about a year and about a month ago it started saying 8psi at idle so I replaced the Map sensor and that didn't work so as soon as I get it back from having the injectors done I'm going to yank the comander to send it back. I aloso lost rail pressure aswell.

 

[Arctic Taco]

maybe just a rough road?

Got back on the road to work, and suddenly I think it's more accurate now. Reads 0 @ idle, coasting, even loafing down hill. So I don't know.
QuadZ said I needed to re enter the hardware and model, etc. . , I had already done that a few times and I guess maybe it took a few tries for it to take?