Here I am

Quadzilla Commander?

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

R2 Coolant

Pretty Impressed

Status
Not open for further replies.
I am going to install gauges. I am wanting to monitor EGT's, Boost, and Trans temp. I have always used analog gauges in the past, but after looking at the commander setup and seeing the other things that can be done, it seems to be a good deal. The cost is not much greater for the digital that is capable of doing more. This is comparing it to three analog gauges with a pillar pod.



You that are using the commander, what do you think? Would you do it again? Any complaints? Pros, Cons?



Thanks
 
O would do it again in a heart beat. it may not be as acurate in some ways but it does a good job. I also like the data logging to let me know the max numbers I see.
 
I have one and have it replaced 2x now for type of short. The customer service is great. It would just quit working and then later it would start working again. If I was to do it again, I would go with the regular gages.
 
same problem as ksnyder and the fuel pressure sensor will not last if you do not use a snubber and mount it on the firewall
 
I have one and have never had a problem with it. I love looking in one place for all the vitals. I have the pilar mount made for it so it turned out to be a clean look and I kept the grab bar on the a-pilar. I had traditional guages on my 03 and found that I like the Commander better. Obviously... everyone has their $. 02.
 
Status
Not open for further replies.
Back
Top