Here I am

Engine/Transmission (1998.5 - 2002) Reading some codes

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

Engine/Transmission (1998.5 - 2002) ISB-or b5.9

2nd Gen Non-Engine/Transmission What is it worth?

Status
Not open for further replies.
:eek: :eek: I need some help trying to find out what these codes mean, and are they bad. I have a full set of gags in the truck along with the Edge Comp. I just found out how to check for codes. I also just put the Edge Comp and new lift pump on last Thursday, I only ran the lift pump I got from Dodge bout 3 weeks, and now put one on from Cummins. Here are the codes I got, I hope someone can decipher them fore me. Thanks.

Mike.

The codes are. p0122, p1693, p1687 :eek: :rolleyes: :confused:
 
From my 2002 service manual. . It shows



p0122 (M) Accelerator Position Sensor (APPS)LowAPPS voltage input below the acceptable voltage

p0122 (M) Throttle Position Sensor Low. Throttle Postion Sensor below the acceptable voltage range



p1693 (M) DTC detected in Companion Module. A fault has been generated in the companion engine control module.

p1693 (M) DTC detected in PCM/ECM or DTC detected in ECM Acompanion DTC was set in both the ECM and PCM



P1687 No MIC BUS Message (No Cluster BUS Message) . No CCD/J1850 messages recieved from the Mechanical Instrument Cluster.
 
Status
Not open for further replies.
Back
Top