Attention: TDR Forum Junkies I know there are a lot of threads out on this subject, but I can't seem to find what I'm looking for on search. I'm making my own lowering blocks from 3 x 6 x 2. 5 plate steel to lower the back of my truck and need to know the exact drill size holes for the top and bottom. I know I can get this off the OEM blocks on my truck, but would like to pre-drill these ahead of time to save time when it comes to tearing down and assembly. Anyone that has done this remember the drill sizes used? Welcome any help or advice.
Thanks
Bob
Thanks
Bob
