Removing instrument cluster bezel on ' 93

[Archive]

Got out the manual and instructions say:
Remove map light, screws under brow, screw above heater/AC, place shifter in "1", pull top edge rearward to clear brow then disengage attaching clips at bottom.
Well these attaching clips are not readily apparent to me and just pulling up is making me nervous.
Any hints?
Thanks!

 

[Archive]

Just keep good even pressure on it and it will pop out. I recently replaced my radio and had mine off. The clips on the bottom they are talking about have a sort of sticky puddy on them to deaden rattle. This causes it to feel like it will never come out. Also as the top leans out reach your hand in by the radio and O/D Bed light opening and pull straight out. Hope this helps.

P. S. on the way back in, go bottom first and make sure that the tabs have plenty of the sticky puddy on them to deaden the rattle.


------------------
92 Ext. Cab, Auto trans. , 3. 54 Non-LS, Isspro Tach and Pyro (pre-turbo), 210,000+ miles, straight pipe,old and abused but still running strong!!!!