Attention: TDR Forum Junkies 
Hi
I have an additional transmission cooler that I would like to plumb between the heat exchanger and the return port on the side of the transmission. Does anyone know how to find out what the thread patterns are on each end of the stock return line? I'd like to replace it completely with hydraulic lines, rather than cut into the stock hard tube line & use compression fittings.
I'm hoping to be able to gather this info and have the lines made up ahead of time, instead of pulling the stock piece and having to take it with me to make sure the fittings match on my new lines when I have them made.
Thanks.
Ben
I have an additional transmission cooler that I would like to plumb between the heat exchanger and the return port on the side of the transmission. Does anyone know how to find out what the thread patterns are on each end of the stock return line? I'd like to replace it completely with hydraulic lines, rather than cut into the stock hard tube line & use compression fittings.
I'm hoping to be able to gather this info and have the lines made up ahead of time, instead of pulling the stock piece and having to take it with me to make sure the fittings match on my new lines when I have them made.
Thanks.
Ben
