Here I am

Rough starts and P 0341 code

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

Had my truck on the dyno

Excessive Smoke

Status
Not open for further replies.
Last week my 2005 with 72 k on it began to skip on startup. Got some blue smoke as well. this only lasted for about 5 seconds and then it cleared up and ran fine. Today the check eng light came on. I read a code P 0341 camshaft position sensor "A" circuit range. My CD manual does not list a P 0341 code. Has the sensor failed or is the code a result of the skip. Or is the skip a result of the failed sensor. I do not think it is a bad load of fuel as I filled up at a Flying J and never had a problem with their fuel. Another thought is are the injectors starting to fail? Any help would be appreciated. Thanks, J Knapp
 
Rough start

My 05 had the camsaft pos. sensor quit on me. The dealer replace it on my warranty. I remember the same code. Roger M.
 
Status
Not open for further replies.
Back
Top