Archived seat rebuild/padding

[PetesonM]

Dumb question but I am in the process of doing the carpet on the springs and adding some Nu-Foam to my seats. It is easy enough to figure out where the carpet goes but does the foam go on top of the factory cushion or below it? I am guessing on top.



Many thanks!

 

[Nate]

Below. PM me your email address, I have a writeup for you another TDR member sent me.

 

[PetesonM]

I am at a buddies house send it to.



-- email address removed --

 

[Mike C]

Nate, can you please email me a set of those directions as I am getting ready to do the same. My email is -- email address removed -- thanks alot.

 

[stacerbob]

I'd like to see that also.

-- email address removed --

 

[Nate]

Sent emails to all of you. It's from an old TDR magazine.

 

[REFLOYD]

could you send me the writeup also. i am thinking about doing it too.

-- email address removed --

 

[PetesonM]

I got one side done and flipped the drivers and pass cushons since the drivers was actually cut clear through on the edge where the frame is. I just glued that back together and figured the pass could deal with it. The rest of the install was pretty easy a little trimming was needed cause of the pad switch but nothing major. Now to get the one side swen back up. I will not have matching colors cause I couldn't find any fabric I though was tough enough but they are much more confortable now.