2nd Gen Non-Engine/Transmission Seattle area, where do I go for front end work?

[sean3073]

I have an 02 2500 CTD with 100K on her. It's time for a new track bar, along with some other assorted front end bearings. Does any one know a good shop in the Seattle, Tacoma Area. Also, does any one have any recomendations for Track Bar's? I am located in Sumner.

 

[wcjp]

Have you tried asking over at Northwest Bombers



I did the Napa tracbar on my 96'. Lifetime warranty. Only buy it one time and swap when necessary. Many enjoy Lukes Link. Shop around for new Unit Bearings. There was a link recently posted here on the TDR. The company that makes the Unit Bearings for Mopar can sell them direct for quite a bit less. There's also Ems Offroad. They sell a hub/bearing kit.

 

[sean3073]

Sounds good. I will look into Ems offroad. Any more pointers in the greater Seattle aera would be great in refference track bar's and ball joints.

 

[Suprmn]

I have had pretty decent work done at Kimballs alignment in Tacoma. Pricing is pretty good too.

 

[SnoKing]

There is an old time alignment place in Ballard that worked on horseless carriages. I believe that they have seen and worked on everything. I believe that is is called Ballard Frame and Axle. Since 1948! SNOKING