Here I am

Engine/Transmission (1998.5 - 2002) Should it take a LONG time for the coolant temp gauge to move when cold?

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff
Status
Not open for further replies.
magaliasram said:
I just went through this with my truck. Couldn't get it to warm up for beans. The comment about the thermostat being stuck open is partially correct. I found that the Thermostat doesn't actually stick open, rather the iner seal deteriorates and the flow of water is not interupted at the Thermostat. I replaced the thermostat and what do you know I am now back to my normal toasty truck. I run about one needle width below the 190 mark. Check the thermostat I will bet the seal around the inside of the valve is shot.

You are right my bud said that he checked his old thermostat and he said it had a rough place on it and was not closing all the way.....
 
The one on the right is the new one?



The one I bought the other day looks like the one on the left. I was told it was the newest revision. Looks like you bought an old stock one.



Jim Brewer said:
Just for extra data . . this is what my stock thermostat looked like when I pulled it out a couple years ago. I have no idea what caused this other than maybe pulling some RPM while it was closed. The new one has been working fine . .



#ad
 
Status
Not open for further replies.
Back
Top