Smarty Revo no smoke(less smoke) settings?

[osiris]

What would the best settings be for the least amount of smoke? I am currently just using the PDA as gauges and have the timing on 2 since i have flux 1s torque is at 2 rail psi is at 3 and the wastegate is still on for now. It does not smoke as bad as 4. 11 but still more than I really care for. Would any other settings be better? Also on the smarty website it says that for rail psi 3 and 4 that they should not be ran over long periods of time due to injection system damage. is this just the injectors or the entire system? Thanks guys

 

[osiris]

also since getting my injectors and the revo programming i get an overboost code. I got it with the wastegate off and i now get it with the wastegate on. The PDA tells me its only hitting 36-37 but i think it reads of the MAP so what amount of boost is needed to hit the overboost code and why am i getting it with the wastegate on?

 

[CumminsBu]

Set the timing to economy, Rail pressure to stock.

 

[osiris]

will the timing be ok with my flux 1's?

 

[Bob Wagner]

yes the timing and flux 1's will be fine

 

[osiris]

so timing at 4 rail psi at stock... what about trq? is 2 good?

 

[Bob Wagner]

2 is good yes

 

[MPerez]

I tow daily and I set my Smarty to stock rail pressure, stock torque management, timing at 4 and original settings of level 1. Minimal smoke that way, and plenty of power for reasonable towing. I tried the other torque management settings and got noticeably more smoke. And you probably don't need a more aggressive throttle response towing anyway. With these settings I no longer blacken the right side of the trailers I tow...