Spacer for grid heater

[NKenny]

I saw a picture of a flow through grid heater on a bgilbert post. Does anyone have one of the industrial air horn spacers or know a part number to get one?



I am rotating the turbo and trying to rotate the air horn so I can connect the two over the valve cover with intercooler hose or freeflowing aluminum. I just need a few inches lift on the air horn so that I can get it to clear the valve cover.



Thank you!

 

[bgilbert]

I sold all my intake parts aways back or I'd get the part number for you. If jleonard was on shore he might be able to get you a part number for a taller 3" ID intake horn. If you were good at fabbing, you could always make what you need or build a tall intake horn out of 3" exhaust pipe and a made up flange.

 

[JLEONARD]

If jleonard was on shore he might be able to get you a part number for a taller 3" ID intake horn

:-laf :-laf



I'm here. NKenny send me an e-mail to -- email address removed -- I can reply with a couple of pics of my set-up. If it's what you're looking for I can see if there is a casting number on the part that Bill scored for me at his favorite boneyard.

Jay

 

[Dman]

This is air intake #3921836. It's from a ISB in a rec vehicle. Used two intake heater castings - one gutted - for height.