Stainless Rocker Panels

[RGramlow]

I am going to install some Rocker Panels, I want to use the wide ones, but that molding piece on the door it too low, I am wondering if anyone has taken that off and moved it up above that rib in the door? or is there a company that makes rocker panels that will fill up that whole area under the molding, the place I looked at getting mine only have 8. 5 wide and 3. 5 inch wide, but I would rather have like 6 or 7 inch wide ones for under there. What have you guys been doing that have molding?

 

[Motofreak]

I found some that are 6" that I have about 1/2 under my molding. Sorry I dont remember the brand, I got it from a local 4x4 shop so it does exist.

 

[RGramlow]

I found some that are 6" that I have about 1/2 under my molding. Sorry I dont remember the brand, I got it from a local 4x4 shop so it does exist.

Okay, I will keep looking I figured that there should be something out there. Thanks alot

 

[claymike]

Yup took off the molding installed NW Custom rockers from Jason Burton

http://www.omnicast.net/~nwcustom/

 

[Cattletrkr]

Anybody put those on the dually fenders? I've heard that the tape won't stick to fiberglass, at least not for very long. If so, that sucks.

 

[claymike]

This is a pic of Big Bobs truck, none on the fenders

 

[DSutton]

I also have the 6" rocker panels, with no molding. I second that it does exist. If needed I could find out where they were purchased. They were a gift for me.

 

[BIG BOB]

Jason at Northwest Custom also does Custom Cutout in them!



#ad




Notice I did move the door molding to the upper part of the door. That was a real pain to get them and the glue off!

 

[RGramlow]

Are those letters stamped in the pannel, or are they stickers? I did find some that will fit, they look to be about 6 inches. Thanks alot

 

[claymike]

They are cut out with a water jet