starter and grid heater...amps??

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

POD's

injetor pump help

Status
Not open for further replies.
Just wondering. How many amps do the grid heaters draw, say, on a zero degree morning? And relating, how many amps does the starter draw? Lets say all the while, it's zero degrees and the truck has been sitting for 10 hours without being plugged in :eek: . I'm asking because I have too small a battery (900 CCA, to be exact - didn't know any better 2. 5 years ago) and I don't quite have the money for a better one just yet, and it's supposed to be 0 degrees tonight, possibly even below that. The moral of the story is, between the grids and the starter, I'm trying to conserve cranking power. My block heater doesn't workl. Any suggestions?



jaynes
 
Jaynes, from my big bad Chilton manual, it says cranking draw test from the starter is 450-550 amps. Don't know about the grid heaters, though I've seen it somewhere. Bill
 
You should be all right. My battery isn't much larger than yours. I have started at -20 with no problems and no heater pluged in.
 
Status
Not open for further replies.
Back
Top