Here I am

stock turbo

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

Axle question?

skobylenski's first gen on the front page!

Status
Not open for further replies.
well i put in the little spring that goes on the top hat inside the ip... had to order a new one cuz i lost the old one when i first took the top off to put the 3200 spring in and while i waited on it to come in i made a spring fit in there and it wouldnt idle in gear it would die but when i did run it i could hold 32psi with the stock turbo and 21cm housing and now with the right spring in there im holdin 36 :D but im peggin the pyro :eek: with it and i turned the fuel scerw im more without it wantin to runaway on me and alot more black smoke now :D ... soo how much hp/tq do yall think im pushin now?
 
He has POD's mentioned in the signature line.



I have similar results. My turbo is an PDR unit modified further by HTT w/ a 21 cm housing. I have the same boost and reach 1500° rapidly.



My guess is that you gained much much more than 40 HP, but I have never tested my truck on the dyno. It's just a guess.



When my truck was OEM it wasn't anything to write home about. Now it shreads the rear tires :eek:
 
yes i do have pods and i can shread the the tires too... my truck comes in at round 6000lbs maybe alittle more cuz of the flatbed and with 305 tires on it and even having to let off the trottle once i still ran a 14. 9 on the 1/4 mile back in dec. and now i have 5" exhaust and the pump like it sould be and smaller tires out back... it feels alot faster now than it did... so idk i need to get it on the dyno
 
Status
Not open for further replies.
Back
Top