Here I am

Engine/Transmission (1998.5 - 2002) Strange lift pump question.

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

Engine/Transmission (1998.5 - 2002) Polished Valve Cover.

2nd Gen Non-Engine/Transmission tie rod replacement

Status
Not open for further replies.
ike said:
This may sound stupid, but what type of gage are you running.



I use a mechanical gauge with an isolator so that's not it. With the last pump I put on it has settled down to 10 lbs. at idle and 8 lbs. under load, a bit lower than I like but not terminal. I might just get the Geno's relocation kit and run one of my 4 spare slightly used pumps in series, that should get the pressure up and provide a bit of redundancy for good measure.
 
Status
Not open for further replies.
Back
Top