2nd Gen Non-Engine/Transmission tie downs...

[THenningsen]

I've got a toolbox in the bed of my truck and was looking for some type of tie down to mount near the front of the bed. The stake holes are covered up by the box. Anyone have any clever ideas?

 

[bsappington]

I went to the hardware store and bought some grab handles. I suppose you could use some kleets but I would get some with holes in the middle and bolted them to the rear of the box. You just have to make sure that your box is secured very well.



Hope this helps,

Ben

 

[R-N-R]

I just use the shell clamps to keep light to medium loads from sliding around. Probably would not work to well to truly secure the box though.

 

[BigPapa]

These work great. Very strong and very easily removed. They are available at most any motorcycle shop:



http://www.americasmotorsports.com/..._product_156726.ANCRA_TIEDOWN_FITTING_KIT.htm



Scott