Here I am

TIE ROD END

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

Front band adjust

EXHAUST ELBOW PART NUMBER

Status
Not open for further replies.

lschultz

TDR MEMBER
Can you buy the drivers side tie rod end just by itself?What we need is just the seal(I call it a grease boot). My son was greasing the right side and the bottom of the boot blew out. All he needs is the boot to replace but I guess you have to buy the end of the tie rod to get the boot. Any suggestions or is this part available?

------------------
2000 Dodge 4x4 Quad Cab SWB 5-SP
2001 VW NB TDI
AMSOIL(#504865) DEALER & USER
 
I make ball joint boots all the time out of puncture proof bicycle inner tubes and stainless steel tie wire, works great and lasts long. But I'm doing this on tractor ball joints that cost $150+ each and who's only problem is the boot. As far as I know boots aren't available separately. You do have to remove the joint to put on the homemade boot, the price of a Dodge joint end might be cheap enough that it isn't worth the hassle for you, they are available, I think even from Napa.
 
I know polyurathane boots are available seperately for jeep tie rods. You may be able to find some at a four whel drive shop.

------------------
ex Ford tech, now driving '01. 5 2500 4X4 QC LB ETH/DEE SLT 3. 54, Patriot Blue
 
Well I'm getting closer to finding one. Called Dodge dealer-you have to buy the whole thing
Federal Mogul-seal comes on tie rod as a complete assy.
NAPA-no luck AUTOZONE-they have 3 sizes there will have to take it off and see if one matches. Thanks for the help.

------------------
2000 Dodge 4x4 Quad Cab SWB 5-SP
2001 VW NB TDI
AMSOIL(#504865) DEALER & USER
 
Check at a 4wd/off road shop. Companies such as Swayaway/Rancho make urethane/colored replacement dust boots for tie rod ends.

Sam

------------------
2001. 5 2500 QC HO 6sp LB 3. 54LS everything except leather, white/agate 2wd,Isspro guauges on the A,ME kit,DD Tru torque module,K&N air filter,Geno's smoothie,chrome tip,RBW hitch

Sam Hill-BPOE #583


Fordaholic-clean and Mopar'd since 10/05/00
 
You could visit any front end shop. I am sure they would let you have one off of an old part.

------------------
98 Properly Valved 4x4 SWB QC ISB A/T Metallic Red w/ tan cloth interior, DC nerf bars, DC two piece mud-flaps, 275 h. p. injectors, Monroe Gas Magnums, Armor Tuff spray in bed liner, Goodyear Wrangler ATS 285/75r/16, BD Heavy Duty Valve body. Walker 21468 thru flow muffler,Cobra 29 NWST CB. American Racing Wheels. Power Edge EZ control module,Tuff Country 2" Leveling System, Draw-Tite Front Mount Receiver.
 
Well I found them. Had email to look at energy supension web site. They have them and it looks like about any type for any car/truck you have. 4Wheel Parts sells them. They are out of the one I need should be in next week. They are sold in pairs for $4
Thanks for the help.

------------------
2000 Dodge 4x4 Quad Cab SWB 5-SP
2001 VW NB TDI
AMSOIL(#504865) DEALER & USER
 
Status
Not open for further replies.
Back
Top