Here I am

Engine/Transmission (1994 - 1998) Tip on replacing front crank seal if you have the cover off...

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff
Status
Not open for further replies.
I did the KDP tab yesterday. I put the crank seal in too since I had the cover off. After a few attempts at getting the seal to go into the cover I amost had to give up. It is the tightest seal I have ever seen! I then put the seal in the freezer and the cover in the oven. 2 hrs. later it went in WAY easier. Hope this helps someone...
 
Status
Not open for further replies.
Back
Top