Attention: TDR Forum Junkies I'll ask a dumb question here. The Quote below is from TSB. It says total toe
in 0. 2° ± 0. 1° if thats the case on a 32" diameter that is just under 1/8" of
toe in. If it is per side then it would be 1/4" on a 32" diameter. Can some one
help me understand what they are saying.
Thanks Chuck E.
"The specification for toe in has been revised to 0. 2° ± 0. 1° total toe in. This change has been shown to improve straight ahead driving performance and should be used whenever a front end alignment is performed. "
in 0. 2° ± 0. 1° if thats the case on a 32" diameter that is just under 1/8" of
toe in. If it is per side then it would be 1/4" on a 32" diameter. Can some one
help me understand what they are saying.
Thanks Chuck E.
"The specification for toe in has been revised to 0. 2° ± 0. 1° total toe in. This change has been shown to improve straight ahead driving performance and should be used whenever a front end alignment is performed. "
