Tool Question

[JCrank]

I have a question regarding a tool I am trying to find. On the band adjustments for our 518 automatic transmissions, I need to find out where I can get a 3/8 drive socket that will fit the odd shaped band adjuster. I have used a 6 mm open end wrench in the past, but could only guess how much torque I was applying. I need a socket so I can use an Inch-Pound torque wrench. Is anyone familiar with what I'm looking for and where I can get one ?

TIA,

JON

 

[sdstriper]

Try an eight point socket. I have found these dirt cheap at pawn shops.

 

[JCrank]

I think I've already tried the 8 point sockets. The band adjuster is round on two sides and flat on two sides.

 

[JLEONARD]

Cut the 6mm wrench... weld it to a junk socket (on center) then use the torque wrench.

As a last resort if you can't find the correct socket.

 

[JCrank]

I hadn't thought of that one. THANKS !

 

[dpuckett]

Crowsfoot socket is another option. Attach it to an extension to gain your clearance around the stuff inside there, and turn to click. It may not be entirely 110% accurate, but it'll be closer than "tight" or "snug"



DC or SnapOn probably have the special socket available for an arm, leg, and fistborn.



Daniel

 

[sdstriper]

5/16 eight point socket, on the 727 it was 72 inch/lbs back off 2 turns and 2. 5 turns, it may be different on the 518.