tools needed to install/takeoff suspension lift?

[Bandit1]

i have a buddy that bought a truck with a 3" skyjacker suspension lift, in order to get it inspected we have to take the lift off and make it stock height. i have another buddy that is willing to swap the lift onto his truck, same exact dodge truck. we are planning on doign it in one day if possible prob take part of 2. anyway just wondering if there are any special tools that are needed in order to this swap. i just put a 6" suspension on another friends PSD the other weekend and it took us an hour of pouding on the pitman arm to get it off, so i am familiar with that beast, anythign else let me know.

 

[TBrennan]

Ptman arm puller (may also need a big wrench with a cheater bar and a torch to heat it up if it's real stubborn), coil spring compressor (make sure they are big enough for the coils you are using), Big C-Clamps for the rear leaf spring pack if your using an add-a-leaf, and a pickle fork or tie rod puller for removing tie rods ends.



Other than that I think all you need are standard hand tools and probably a big honkin hammer for stubborn parts!

 

[y-knot]

You forgot only one thing... ..... Case of beer

 

[lmills]

Originally posted by y-knot

You forgot only one thing... ..... Case of beer

you obviously haven't worked with thbese guys before. You meant to say two cases of beer!

 

[Bandit1]

you can come up to if you want to loyd, there will be plenty of beer, more than the last time bc i plan on pounding down the brews as soon as i have a tool in my hand, prob around 8am. you are more than welcome. beer helps get those stubborn bolts loose.

 

[lmills]

Shoot me a pm with a when and where. I will try to make a showing