top dead center

[JMiltier]

how to correctly set top dead center on a 12v for a valve adjustment

 

[MRector]

Use the timing pin on the back of the timing case, under the pump.



Fritz's directions



Mikey

 

[JMiltier]

can u get the 6 in-lb wrench from snap-on? thanks

 

[MRector]

can u get the 6 in-lb wrench from snap-on? thanks

Dont know about the snap-on, I guess you could cross reference the part# to them and see. I just used the old, "6-inch pounds elbow trick" :-laf



Mikey

 

[Alan Reagan]

I use the companion cylinder method, also on the Fritz website under the alternate methods.



When I had my 98, I could never get the timing pin to go in. It was stuck. However, if you use the timing pin, make sure that you disengage it before turning the engine or you'll break it off.