Torque on front spindle nut-Dynatrac

[steved]

I got to tighten the hub spindle nuts on my Dynatrac hubs. Anyone have that procedure??



I'm talking the nut that tightens the wheel bearings. I seem to remember 75ft-lbs and back off 1/3 turn???

 

[bmoeller]

At least on big trucks, most are TQ to 50lbs and back off one-half turn. That is assuming the races weren't replaced.

 

[steved]

Thanks, I eventually found my DT install instructions a few minutes ago... its 50 ft-lbs, back off 1/8-1/4 turns...

 

[bmoeller]

Good deal.